中華人民共和國國家標準(中國大陸GB標準)英文版 |
GB標準是中華人民共和國國家標準,也叫GB國標,是中國大陸強制執行的國家標準,所有中國大陸境內銷售的商品及提供服務都必須符合GB國家標準的要求,包括進口商品及服務; 本網站提供GB國家標準的查詢檢索,英文版翻譯,GB標準產品檢測檢驗及合規性分析服務; |
NB/T 47002.4-2009 壓力容器用爆炸焊接複合板 第4部分:銅—鋼複合板(中英文版) Explosion welded clad plate for pressure vessels. Part 4: Copper-steel clad plate |
|||
GB/T 24504-2009 煤層氣井注入/壓降試井方法(中英文版) The method of injection/falloff well test for coalbed methane well |
|||
DL/T 402-1991 (中英文版) (Chinese Industry Standard) |
|||
GB/T 16060-1995 車間空氣中丁酮的直接進樣氣相色譜測定方法(中英文版) Workplace air--Determination of butanone--Direct injection gas chromatographic method |
|||
JJF 1246-2010 製造計量器具許可考核通用規範(中英文版) General Rules for the Examination of the Certificate of Manufacture Metrological Appliance |
|||
GB 19521.2-2004 易燃液體危險貨物危險特性檢驗安全規範(中英文版) Safety code for inspection of hazardous properties for dangerous goods of flammable liquid |
|||
GB/T 7962.5-2010 無色光學玻璃測試方法 第5部分:應力雙折射(中英文版) Test methods of colourless optical glass - Part 5: Stress birefringence |
|||
HJ 707-2014 環境雜訊監測技術規範 結構傳播固定設備室內雜訊(中英文版) Techniacal specifications for environmental noise monitoring structure-borne indoor noise form associated facilities |
|||
GB 7000.2-2008 燈具 第2-22部分:特殊要求 應急照明燈具(中英文版) Luminaires - Part 2-22: Particular requirements-luminaires for emergency lighting |
|||
GB/Z 19848-2005 液壓元件從製造到安裝達到和控制清潔度的指南(中英文版) Hydraulic fluid power-Component cleanliness-Guidelines for achieving and controlling cleanliness of components from manufacture to installation |
|||
SJ/T 10288.10-1991 鎘鎳圓柱密封鹼性蓄電池 gnyz0·18鹼性蓄電池(中英文版) GNYZ0. 18 alkaline rechargeable battery |
|||
HG/T 3806-2006 分散紅s-g 200%(分散大紅gs 200%)(中英文版) Disperse Red S-G 200% (scattered red GS 200%) |
|||
GB/T 33441-2016 海洋能調查品質控制要求(中英文版) Quality control requirment of ocean energy investigation |
|||
GB/T 29762-2013 碳纖維 纖維直徑和橫截面積的測定(中英文版) Carbon fibre - Determination of filament diameter and cross-section area |
|||
GB/T 1508-2002 錳礦石 全鐵含量的測定 重鉻酸鉀滴定法和鄰菲囉啉分光光度法(中英文版) Manganese ores--Determination of total iron content--Potassium dichromate titrimetric method and 1,10-phenanthroline spectrophotometric method |
|||
HG/T 2696-1995 iso 100/21°彩色照相膠捲(中英文版) (ISO 100/21 Degree color photographic film) |
|||
SJ/T 11041-1996 電子玻璃抗衝擊強度測試方法(中英文版) Test method for impact resistance strength of electronic glass |
|||
CJJ/T 239-2016 城市橋樑結構加固技術規程(中英文版) (Technical specification for reinforcement of urban bridge structure) |
|||
GB/T 22376.1-2008 膠粘劑 本體試樣的製備方法 第1部分:雙組份體系(中英文版) Adhesives - Methods of preparing bulk specimens - Part 1: Two-pawrt systems |
|||
TB/T 2452.1-1993 整體薄壁球鐵活塞無損探傷 球鐵活塞超聲波探傷(中英文版) (Whole squash thin iron piston NDT. Ductile iron piston ultrasonic flaw) |
|||
GB/T 37967-2019 基於XML的國家標準結構化置標框架(中英文版) Tagging framework based XML structurizing of national standard |
|||
GB/T 5169.31-2008 電工電子產品著火危險試驗 第31部分:火焰表面蔓延 總則(中英文版) Fire hazard testing for electric and eletronic products - Part 31: Surface spread of flame - General guidance |
|||
GB/T 34597-2017 乘用車 防抱制動系統(ABS)直線制動距離 開環試驗方法(中英文版) Passenger cars—Stopping distance at straight-line braking with ABS—Open loop test method |
|||
GB/T 20255.5-2006 硬質合金化學分析方法 鉻量的測定 火焰原子吸收光譜法(中英文版) Methods for chemical analysis of hardmetals - Determination of chromium content - Flame atomic absorption spectrometric method |
|||
GB/T 35095-2018 π尺(中英文版) Pi tapes |
|||
YY/T 0173.6-1994 手術器械 鎖止牙(中英文版) (Surgical instruments. Locking teeth) |
|||
GB/T 10963.3-2016 家用及類似場所用過電流保護斷路器 第3部分:用於直流的斷路器(中英文版) Circuit-breakers for overcurrent protection for household and similar installation—Part 3: Circuit-breakers for d.c. operation |
|||
SB/T 11067-2013 金屬材料倉儲技術與管理規範(中英文版) Metal material storage technology and management specification |
|||
GB/T 20139.1-2016 電氣絕緣系統 已確定等級的電氣絕緣系統(EIS)組分調整的熱評定 第1部分:散繞繞組EIS(中英文版) Electrical insulation systems—Thermal evaluation of modifications to an established electrical insulation system(EIS)—Part 1: Wire-wound winding EIS |
|||
GB/T 35765-2017 陸地國界測繪規範(中英文版) Specifications for national land boundary surveying and mapping |
|||
GB/T 274-2000 滾動軸承 倒角尺寸最大值(中英文版) Rolling bearings--Chamfer dimension--Maximumvalues |
|||
GB/T 17394.2-2012 金屬材料 裡氏硬度試驗 第2部分:硬度計的檢驗與校準(中英文版) Metallic materials - Leeb hardness test - Part 2: Verification and calibration of hardness testers |
|||
QB/T 4418-2012 10-十一烯酸(中英文版) 10-Undecenoic acid |
|||
SY/T 6308-1997 油田爆破器材安全使用推薦作法(中英文版) Recommended practice for oilfield explosives safety |
|||
GB/T 10051.2-2010 起重吊鉤 第2部分:鍛造吊鉤技術條件(中英文版) Lifting hooks - Part 2 :Technical conditions for forged hooks |
|||
SN/T 3756-2013 玉米細菌性枯萎病菌檢疫鑒定方法 PCR方法(中英文版) Detection and identification of Pantoea stewartii(Smith)Mergaert et al. PCR method |
|||
QB/T 1927.9-1993 漂白池能量平衡及熱效率計算方法(中英文版) (Bleaching pool and thermal efficiency of the energy balance calculation method) |
|||
YD/T 2015-2009 iptv業務管理系統體系架構(中英文版) Architecture for IPTV service management system |
|||
SY/T 0077-1993 天然氣凝液回收設計規範(中英文版) Design Specification of Natural Gas Liquid Recovery |
|||
JC/T 733-1987 水泥回轉窯熱平衡測定方法(中英文版) Methods for the measuring of heat balance of cement rotary kiln |
|||
GB/T 4930-2021 微束分析 電子探針顯微分析 標準樣品技術條件導則(中英文版) Microbeam analysis—Electron probe microanalysis—Guidelines for the specification of certified reference materials (CRMs) |
|||
GB/T 32348.2-2015 工業和商業用電阻式伴熱系統 第2部分:系統設計安裝和維護應用指南(中英文版) Electrical resistance trace heating systems for industrial and commercial applications—Part 2: Application guide for system design, installation and maintenance |
|||
JT/T 8100.31-1992 船用通信導航設備的安裝、使用、維護、修理技術要求 氣象傳真機(中英文版) (Marine communications and navigation equipment installation, use, maintenance, repair, technical requirements for weather fax) |
|||
SH/T 1490-1992 石油對二甲苯結晶點測定法(中英文版) (Oil paraxylene crystallization point assays) |
|||
SN/T 1838-2006 具節山羊草檢疫鑒定方法(中英文版) Identification of Aegilops cylindrica Horst |
|||
JJF 1261.3-2015 家用電磁灶能源效率標識計量檢測規則(中英文版) Rules of metrology testing for energy efficiency label of household induction cookers |
|||
YD 5084.3-2015 交換設備抗震性能檢測規範 第三部分:移動通信核心網設備(中英文版) (Switching equipment seismic performance testing specification - Part 3: mobile communication core network equipment) |
|||
FZ/T 52004-2007 充填用中空滌綸短纖維(中英文版) Hollow polyester staple fibres for filling |
|||
GB/T 24769-2009 工業用丙烯醯胺(中英文版) Acrylamide for industrial use |
|||
DL/T 5383-2007 風力發電場設計技術規範(中英文版) Technical specification of wind power plant design |
找到:115477條目 | [首頁]-[上一頁]-[下一頁]-[尾頁] | 去到: [1189] [1190] [1191] [1192] [1193] [1194] [1195] |